In a newly developed hydrogen train for local transport, a pressure switch from WIKA plays a crucial role. Within Repulsed of pressure monitoring, it performs the central safety function in the H2 supply system during the journey.
The advantages of hydrogen in rail transport are rather unknown to everyone. Even if the first trains with H2 fuel cells are already in operation. They are powered by non-electrified railway lines and replace the diesel trains which were used before.
Improved predicated on carbon fibre composite technology
The tank convenience of the hydrogen should be adapted to the distances. One of WIKA?s customers has specialised in individual fuel storage systems for H2 vehicles. Restricted derive from carbon fibre composite technology. They’re therefore extremely robust yet have a relatively low weight compared to steel vessels.
Tanks of the type are also installed in the hydrogen-powered train mentioned at the beginning. This multiple-unit train, designed for commuting traffic, is filled with the hydrogen at a particular terminal. The tank pressure is 300 to 350 bar. While driving, it should be reduced to a single-digit value for the supply to the fuel cell. This is done via a pressure regulation unit downstream of the storage system.
Pressure switch in hydrogen-powered train switches the drive system off
Suitable for use in a new kind of hydrogen-powered train with regards to safety ? the model PXA pressure switch from WIKA.
The pressure switch model PXA meets the requirements of the hydrogen-powered train application. With the monitoring the of tank pressure and pressure regulation in the hydrogen-powered train, the customer uses the pressure switch model PXA for the safety function. The miniature instrument switches off the H2 propulsion system in two cases, depending on function:
if the tank is in danger of emptying
if the pressure becomes too much when the hydrogen is transferred to the propulsion system
Such an emergency protection could also be realised with a pressure sensor and a software. But also for trains this solution will be very complicated. It is also rated with a higher risk of error than a switch-based safety function.
SIL-3 approval made the case for its use
The customer did not choose the model PXA because of its measurement quality alone. The pressure switch was also considered right for the duty in the hydrogen-powered train due to the SIL-3 suitability. It thus easily meets the safety-related market requirements for the H2 application (SIL-2).
Flameproof enclosure (?Ex d?) and compact design
The PXA in addition has been designed for ambient temperatures from -40 �C to +85 �C. In addition, the pressure switch has IECEx approval ?Ex d? (flameproof enclosure), that your customer requires as standard. An additional advantage of this instrument: The PXA could possibly be easily built-into the storage system thanks to its extremely compact design.
Note
Further information about hydrogen and on the pressure switch model PXA can be found on the WIKA website. For those who have any questions, your contact will gladly gelp you.
Also read our posts
Wika develops pressure sensor for hydrogen-powered vehicles
Hydrogen mobility: Clean engines into the future offer the same convenience as engines today
Turning hydrogen into kilometres
Hydrogen and pressure sensors ? What should be observed?

Leave a Reply