If the precise pressure sensor design of the submersible pressure transmitter or level probe is selected to gauge the filling levels, this often means that the probe is used under environmental requirements which may cause failure of common level sensors.
The most adverse conditions such as for example soiled media, abrasive ingredients and sludge when found in wastewater treatment plants, brackish and wastewater tanks or even digester towers, impose special requirements on the design of a submersible pressure transmitter. One of many requirements on a submersible pressure transmitter would be to have the lowest possible susceptibility to contamination or build-up of the pressure sensor by optimizing its design. For this reason the normal design of a pressure transmitter with narrow pressure ports is not used within level probes since it would have a tendency to clog in such applications.
The look of the submersible pressure transmitter and its own pressurised sensor diaphragm is optimised to experience suprisingly low susceptibility to contamination. However, continuous operation in soiled media may lead to sticking of dirt particles on the stainless steel diaphragm. To obtain the highest accuracy and fastest response times in the event of level change, the thickness of the stainless steel diaphragm is already minimised ex factory to just a few microns. Therefore, cleaning of the diaphragm must be carried out with caution. Always avoid using sharp or edged tools. It is also strongly advised never to use the popular screwdrivers or pens.
If cleaning of the sensor diaphragm is essential, then rinse it using a weak water jet or clean it carefully using compressed air. Damage of the diaphragm because of denting or notching, even though it appears to be purely superficial, leads to significant losses in the accuracy of level measurement. Deformation of the diaphragm often shifts the zero point of the pressure measurement in the inner electronic measurement system and additionally distorts the output signal linearisation which has been adjusted ex works to the undamaged diaphragm. Thus, the submersible pressure transmitter with damaged diaphragm generates falsified measurement of the existing filling level and, therefore, can’t be considered a trusted measuring instrument any longer. Thus, Reliable of the damaged instrument is completely necessary.
Please find more info with this topic on our information platform ?Hydrostatic level measurement?